澳门尼斯人手机网站-澳门尼斯人娱乐场

澳门尼斯人手机网站 设为首页 - 加入收藏 - 技术博客 - 网站地图
   齿轮马达
RR系列同轴式斜齿澳门尼斯人手机网站
RS系列斜齿轮-蜗轮澳门尼斯人手机网站
RK系列斜齿-螺旋锥齿轮澳门尼斯人手机网站
RF系列平行轴斜齿澳门尼斯人手机网站
   行星澳门尼斯人手机网站
RP系列行星澳门尼斯人手机网站
   重载齿轮箱
RHB工业齿轮箱
RM系列大型工业减速器
   高速齿轮箱/增速箱
R高速齿轮箱/增速箱
   风电齿轮箱
R风电齿轮箱
   三相异步电动机
R三相异步电动机
博能澳门尼斯人手机网站配合伺服电机会提高使用性能降低设备成本

现代工业设备应用中在高精度应用场合随着伺服马达技术的发展,从高扭矩密度乃至于高功率密度,使转速的提升高过3000rpm,由于转速的提升,使得伺服马达的功率密度大幅提升。这意谓着伺服马达是否需要搭配博能澳门尼斯人手机网站,其决定因素主要是从应用的需求上及成本的考虑来审视。

The application of modern industrial equipment in the high precision servo motor applications with the development of technology, from the high torque density and high power density, the high speed increase of 3000rpm, due to the speed increase, the power density of the servo motor significantly improved. This means that the servo motor is the determinant factor of collocation Boneng reducer, mainly from the application demand and cost considerations to examine.

1、提高使用性能:据了解,负载惯量的不当匹配,是伺服控制不稳定的最大原因之一。对于大的负载惯量,可以利用减速比的平方反比来调配最佳的等效负载惯量,以获得最佳的控制响应。所以从这个角度来看,博能澳门尼斯人手机网站为伺服应用的控制响应的最佳匹配。

1, improve the use of performance: it is understood that the improper matching of load inertia, is one of the biggest reasons for the instability of servo control. For large load inertia, the ratio of the reduction ratio can be used to allocate the optimal equivalent load inertia, in order to obtain the optimal control response. So from this point of view, the best match for the application of the servo reducer polar response.

2、增加设备使用寿命:行星博能澳门尼斯人手机网站还可有效解决马达低速控制特性的衰减。由于伺服马达的控制性会由于速度的降低,导致产生某程度上的衰减,尤其在对于低转速下的讯号撷取和电流控制的稳定性上,特别容易看出。因此,采用博能澳门尼斯人手机网站能使马达具有较高转速。

2, increase the service life of the equipment: planetary gear reducer Boneng can also effectively solve attenuation characteristics of low speed control motor. Because the control of the servo motor as the speed decreases, resulting in attenuation to a certain extent, especially in the low speed signal acquisition and stability of current control, especially easy to see. Therefore, the speed reducer can make Boneng has the high speed motor.

3、降低设备成本: 从成本观点,假设0.4KW的AC伺服马达搭配驱动器,需耗费一单位设备成本,以5KW的AC伺服马达搭配驱动器必须耗费 15单位成本,但是若采用0.4KW伺服马达与驱动器,搭配一组博能澳门尼斯人手机网站就能够达到前述耗费15个单位成本才能完成的事,在操作成本上节省50%以上。

3, reduce the cost of equipment cost: from the point of view, AC servo motor hypothesis 0.4KW collocation drive, consumes a unit cost of equipment, with AC servo motor 5KW driver must cost 15 collocation unit cost, but if the 0.4KW servo motor and a speed reducer drive, collocation can achieve the group Boneng 15 unit cost to cost done, in the operation cost savings of more than 50%.


日期:2016/12/5 14:27:25
咨询QQ
点击这里给我发消息

澳门尼斯人手机网站|澳门尼斯人娱乐场

XML 地图 | Sitemap 地图