摩擦热对澳门尼斯人手机网站中油温的影响部分国产减速箱加油及换油周期频繁,最短甚至天天都要检查,2~3月就得进行换油,即使是进口减速箱换油周期也得最少保证一年两次,润滑剂消耗量特别大。 The effect of friction heat on the temperature of the domestic reducer reducer refueling and oil change cycle frequently, even the shortest every day to check, 2 ~ March to oil, even imported gearbox oil cycle to ensure at least two times a year, the lubricant consumption is particularly large. 澳门尼斯人手机网站油温通常要求在70℃左右,油温高是减速箱润滑失效的主要原因,具体体现在以下几方面:润滑油粘度急剧下降,润滑油乳化;引起摩擦局部油膜破坏,润滑失效,降低设备承载能力;导致齿轮断齿、胶合、点蚀及异常磨损,降低设备寿命;润滑油碳化,积碳,形成渣滓;降低油封寿命;其中油温高导致设备中齿轮的异常磨损,减少设备的寿命。设备中齿轮的异常磨损也会导致油温升高,如此恶性循环,设备快速损坏。 Slow down the oil temperature is usually required in 70 degrees Celsius, high temperature is the cause of reduction box lubrication failure, specifically embodied in the following aspects: the oil viscosity decreased rapidly, emulsification of lubricating oil; oil film friction caused by local damage, reduce the equipment lubrication failure, bearing capacity; cause of tooth broken, gluing, pitting and abnormal wear, reduce equipment life; lubricating oil carbonization, carbon deposition, the formation of dross; reduce the seal life; the high temperature lead to abnormal wear of equipment in gear, reduce the service life of the equipment. The equipment in gear abnormal wear will lead to temperature rise, such a vicious spiral, rapid damage of equipment. 造成油温高的主要原因是润滑剂不能在摩擦面形成油膜来保护设备,从而产生大量的摩擦热,摩擦热促使油温升高,致使润滑剂的润滑效果进一步下降,最终造成润滑剂失效变质,设备磨损。 The main reason is caused by the high temperature lubricant can not form oil film to protect the equipment on the friction surface, resulting in a lot of friction heat, friction heat to the temperature, the lubricating effect of lubricant drops further, resulting in deterioration of lubricant failure, equipment wear.
|